Posted by TX656 on January 14, 2009 at 20:27:31 from (18.104.22.168):
In Reply to: Vermeer 605f round baler posted by shweebies on January 13, 2009 at 12:55:05:
Bought my first round baler last year. It is a 605f. Hadn't been run in a while. Read the owner's manual (which is not that great), read EVERY post on this board that had anything to do with a Vermeer baler, installed new pressure gauge and fluid for the hydraulic cylinder, greased everything plus chain lube, replaced missing teeth, had to run it a while to loosen up belts, etc. End result after not too much work was it bales GREAT. At least the cows I just gave a fresh bale to tonight think so.
I raked 2 7' rows together, drove in a weaving pattern over the windrow like the manual and posters on this board suggested and after about 5 bales they started to look just like all of the neighbors. We won't talk about what some of the first 5 bales looked like. I think the GIANT MUSHROOM BALE was my favorite. That's the one you make when your looking where your weaving instead of watching the baler so you have WAY too much hay in the chamber and also happen to pull the wrong remote lever and open the rear door instead of the operating the twine arm.
I tell my wife I can't wait for May but she just doesn't understand the excitement of the first cut.
Rolling up the hay with the new to me 605L Vermeer baler. Oliver 1750 diesel providing the power! Maintain your Vermeer® machines with our selection of aftermarket new, used, and rebuilt parts. Worthington Ag Parts has been a trusted source of components for over 50 years. We have earned that trust by ensuring every part is cleaned, checked, and repaired to make sure our customers receive ready-to-use quality parts.
Upload PhotoSelect Gallery PhotoAttach Serial # ListReturn to Post
Vermeer 605f Manual Pdf
|TRACTOR PARTS||TRACTOR MANUALS|
|We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]|
Today's Featured Article - Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised 'baccer' (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing 'baccer' sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to ... [Read Article]
Latest Ad: i am wanting to buy either a complete john deere 10a hammer mill or a john deere roughage mill. i am needing parts for the 114 that i own. Please email me or call me [email protected] or call me at 7654141184[More Ads]
Vermeer 605f Parts List
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.